Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Help me think this out here!!!

Posts

Help me think this out here!!!

#1

Help me think this out here!!!

Rob Hix - King George, VA

>Hey all,

I am building some bookshelves and I the plywood I am using has a little warp to it. Specifically it appears to start about 2 feet from one end and it warps up about 1/4" over that 2 feet.

I am putting a shelf (the bottom) right at the bottom of the side, it will be glued and screwed into a rabbet. I am also putting a fixed shelf at about 27" up the sides. At the top I am using a 2" wide nailer across the front of the shelf and and a 2-1/2" wide nailer across the back of the unit.

Where would you locate the worst of this bending? It is not bad enogh that it will not straighten out. Just wondering where you would put it?

Thanks for your input,

Rob Hix

Re: Help me think this out here!!!

#2

JL

Re: Maybe I'm not clear on the concept...

JL

>(wouldn't be the first time).

I think that if you have a deep enough rabbet, it will "straighten" out your warp so that it doesn't matter. That being said, how are you "edging" your plywood? I usually use a piece of hardwood on the front edge of the shelves so I don't have to worry about it (and it sags less with the many lbs of books that I have on my shelves).

Re: Help me think this out here!!!

#3

Jim in Burlington Ont.

Crooked shelves

Jim in Burlington On

>I'd save it for some other job and buy a new flat sheet. Nothing worse than wavy shelves.

Re: Help me think this out here!!!

#4

Re: Help me think this out here!!!

Jim Dillon

>Rob,

If I understand you, the warp is in the side of the bookcase. If so, I would think that your fixed shelf in the middle (? - you didn't say how tall the bookcase is) of the bookcase would pull the plywood in the 1/4 inch or so. The fixed shelf should be in a dado, well glued and clamped overnight. I don't see the need for screws in the bottom shelf - usually glue is good enough. And will there be a back on this bookshelf or is it some sort of hanging bookshelf with no back? Bookcases take a lot of weight (especially floor standing ones) and a back is almost mandatory to control racking. Just some thoughts.

Jim

Re: Help me think this out here!!!

#5

Re: Help me think this out here!!!

Rob Hix - King George, VA

>Sorry, maybe I did not include engough information. First, these are floor standing built-in bookshleves. They do have 1/4" backs which I plan to staple on with a generous amount of staples. The sides themselves are aroun 90" long. They will be attached to the wall at two points along the back of the shelf, and to each other or the wall along the sides of the shelf.

I looked again last night, and the warp is not so bad. It is more like what I have seen in other plywood. Plus, when I push down on the raised portions to flatten it out, first I do not have any trouble flattening it out, and second it causes no other "pop-ups" to appear.

Yes, a couple of my shelves are slightly bowed, but I am putting a 1-5/8" wide edge banding along the edges of those shelves on both the front and the back to support the book weight.

Thanks for all the help so far. I was thinking putting the worst bow at the bottom would be the answer.

Thanks again,

Rob Hix