>Biscuits that is. I seem to remember reading in one of the magazines that gluing biscuits on a large panel is unnessary. So I am giving it a shot on a Coffee table. I cut the slots for the biscuits installed them and used them for alignment purposes. Have any of you folks out there tried this or heard of this approach. Thanks.
>If you prepared the face of the surfaces properly, then the glue-line is stronger than the undisturbed wood around it, so gluing the plates in is not necessary.
However if you do a bad job of preparing the jointed surfaces, the biscuits may be all that holds it together.
Whenever I glue up a panel, it is normally longer than the finish length. I make a practice of breaking the waste pieces after cutting to length as measure of "quality control". If it breaks on the glue-line, it is time to pull out the magnification tools.
>When a table top was sanded flat (with a timesaver) the same day as the glue up. In theory, if the wood around the biskits equilibrates before sanding the top, it should be ok.
Personally, I don't use 'em at all, using cauls and care to align the boards.