Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Clear Wood Filler?

Posts

Clear Wood Filler?

#1

Clear Wood Filler?

matt - richardson, tx

>I am completing work on a couple of bartops made from salvaged heart pine beams and was wondering what I can use to fill in the various defects from old nails that I have pulled out of the boards. I want to be able to still see the defects, but want to eliminate the holes themselves so they don't collect dust and debris. What kind of clear liquid filler could I put into these defects? I am using Waterlox as the finish.

Thanks,

Matt

Re: Clear Wood Filler?

#2

Re: Clear Wood Filler?

Bob McGovern

>Stick some tape to the underside & uses a good two-part epoxy. Stuff will both stabilize the crack/knot/defect and fill it without shrinkage. If you use a slow-curing version like West Systems, most bubbles will have time to evolve out & the result sands & finishes very well. I like to overfill slightly & shave it nearly flush with a chisel. Cheers!

Re: Clear Wood Filler?

#3

Re: Clear Wood Filler?

Rob Stokes in North Vancouver

>Agree with the epoxy.

If you warm it (not hot, just warm - stick the container in hot water for a while)prior to mixing the two parts, the viscosity will go down and it will flow into the nooks and crannies better and faster. This means less "slump" as the thickening epoxy creeps into various cracks before it sets off and there's less chance the resulting solid will have a hollow in top.

But know also that when you warm the epoxy you're going to shorten your working time. All the more reason to use the 20-minute stuff and not the 5-minute stuff.

I over-fill the void a bit, chisel the "almost hard" epoxy off before it sets hard (you can also use an old block plane to do this), and sand the rest of the overfill off later.

Remember also that when you sand the plug down after it's popped off, you don't need a mirror finish on it. Sand it as you do your wood (220) and the clear filming finish you use on top will restore the clarity of the surface of the epoxy.

Oh - when you sand it, don't concentrate your sander over top of the plug. The hardness of the epoxy will be more than that of the surrounding wood and the soft pad on your sander means you'll end up digging a hollow in the wood.

No - I won't explain how I know this :)

Rob

Re: Clear Wood Filler?

#4

question?

Bill Tindal, E.TN

>Is there a problem with epoxy turning yellow and looking ugly with time?