Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Where hardwood lumber comes from 5- mill front end

Posts

Where hardwood lumber comes from 5- mill front end

#1

Where hardwood lumber comes from 5- mill front end

Bill Tindal, E.TN

>Part 5 Mill Front End

This picture shows an overview of the front end of a typical mill. The yellow booth is where the sawyer sits. A joy stick with buttons controls various hydraulic devices and motors that move the debarked logs along the skid way, lift the log onto the saw carriage, rotate the log on the carriage, set the dogs, position the log to saw a set width of board, advance the log through the saw and control where the board or slab goes when it falls from the saw.(more on these parts tomorrow) It should be apparent that this is the most highly skilled job at a mill. A 19 year old wisp of a sawyer occupies this booth and he runs everything on this end of the mill. In the old days three very strong men would be needed at this end of the mill.

The circular saw is shown in left center with the end of a log behind it ready to go through the saw. The saw is driven by belts from the blue electric motor, probably around 100 HP. The green conveyor can be swung with the red hydraulic cylinders to direct the slabs seen on the belt to the chipper, finished boards to the �green chain� or cants to a gang saw. More on these parts in later installments.


img