Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Rockwell 22-201 planer - - head bearings

Posts

Rockwell 22-201 planer - - head bearings

#1

Rockwell 22-201 planer - - head bearings

Pete in Holland, MI

>Guys -

The recent aquisition this past Friday of a Rockwell 22-201 planer (for free, as mentioned on a thread early last week) has shown that the machine has a couple minor cracks that need to be welded. It appears to havve fallen over at one point in its career. Further analysis showed the cutter head ball bearings bearings are toast and need replacment.

Has any one who owns/owned one of the planers ever replaced the cutter head bearings ? Is there anything I should know about replacing the bearings, other than standard ball bearing practices ? I found it interesting that the parts book only showed the cutter head WITH bearings installed, and that sent up a flag in my mind.

Thanx !

Pete

Re: Rockwell 22-201 planer - - head bearings

#2

Re: Rockwell 22-201 planer - - head bearings

Larry Clinton At Frankfort (Central)., Indiana

>I don't have that planer, but changing the bearings should not be a big deal. I have replaced the head on my Yorkcraft with the Byrd unit - bearings just lightly pressed on the shaft. Remember Delta had to assemble it - I have never seen a machine like your planer that didn't have fairly easily replaceable bearings. (in over 39 years working as a manufacturing /quality engineer). If you don't have the pullers etc. . I would take the head to a local machine shop (many auto parts store have a shop equipped and are capable of replacing the bearings - usually for a small charge. They will also likely have the bearings available - or will obtain them - at a slightly higher cost than you can purchase them from a bearing supplier.

Re: Rockwell 22-201 planer - - head bearings

#3

Just last week

ScottM

>I have had mine for about 15 years now. I completely rebuilt it when I got it and the bearings went out last week.

Rockwell wanted $270.00 for the bearings, I found them at a bearing supply for under a $100.00.

The bearings go on the shaft and then into the machine. Watch the cast rings that go around the bearings on the inside of the machine (the pivot point for adjusting the pressure bars) as these are very weak.Also watch the gears and oil level in the gear box for the roller drive (around $700.00).

ScottM

Re: Rockwell 22-201 planer - - head bearings

#4

Rick L

Re: Good planer...

Rick L

>If that's the 18" Rockwell it's no big deal if you have some basic bearing replacement experience. Get your bearings at www.bearingbrokersinc.com I've worked on that machine in many schools and several friends shops and have one in my shop.