Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

miter gauge setting on table saw

Posts

miter gauge setting on table saw

#1

miter gauge setting on table saw

tom morrison

>this is a rookie question- i want to cut a piece of 1x6 to a measurement of 9 inches on one side and 11 inches on the other side. ( a slope of 2 inches for sides to a birdhouse)

two questions:

1. how do i figure out how to set the miter gauge on a table saw to cut this "slope" of two inches?

2.once the sides are cut with the 2 inch slope and attached to a flat back, how do i calcuate the corresponding bevel to cut on the top which will fit flush with the back.( no gap)

thanks

Re: miter gauge setting on table saw

#2

Re: miter gauge setting on table saw

Al Stokka - Cambridge, Iowa

>Tom,

Requires trig.

If your 1x6 is actually 6 inches wide, set you miter gage to 18.434�

If, as I suspect, your 1x6 is actually 5�" wide, set your miter gage to 19.98� [20� should be close enough. ;^) ]

Fro the cut on the top of the birdhouse, the angle will be the same as the angle of the side (18.434� or 20�). Set the blade bevel to that figure.

Al