Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

how would you do this

Posts

how would you do this

#1

how would you do this

Paul R

>My plan is to dye 2 small chests of drawers made of birch that I made for my daughters. I will be using water based dye (analine).

My plan is to sand to 320 grit /wet to raise grain/ resand with 320 grit/then dye/then topcoat with viping varnish.

Would I be better to shellac first then dye?

Any thoughts

Quebecnewf

Re: how would you do this

#2

Re: how would you do this

Sue McLam in Orange, VT

>Paul,

Definitely dye it first. Your process is accurate.

Sue

Re: how would you do this

#3

Re: how would you do this

Thomas Skaggs, Foothills of Mount Level

>I agree with Sue. I will add that I recommend creating a test with some of your birch cutoffs to make sure the dye is to your liking before you apply the dye to the project itself.

Tom

Re: how would you do this

#4

Re: how would you do this

John Lucas

>The finish really changes the color and intensity of the dye. Some times a really large amount. do a test first as recommended. This also solves any incompatability problems before they become a problem. I think you procedure will work just fine. Most of the time I'll raise the grain twice. If you sand too much the dye will still raise the grain slightly. A second application of water and light sanding usually solves this.

Re: how would you do this

#5

Re: how would you do this

Jesse in New Mexico

>Should work. Agree with all who said to test it on scrap. If the varnish muddies the dye, try putting a wash coat of shellac on the dye before the varnish.