Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

use for an old router motor?

Posts

use for an old router motor?

#1

use for an old router motor?

JohnInPV

>Question - I have a 5 year old Sears router with the housing threads worn out so I can't adjust the depth of cut. (plastic threads! I know, I know!). The motor is perfectly fine. Does anyone have any suggestions for a use for this high speed motor? I tried hooking it up to the wheel in our gerbil's cage - it worked fine but the gerbil is now about midway between Earth and Mars. Any ideas on a better use? Thanks in advance.

Re: use for an old router motor?

#2

Re: use for an old router motor?

DB

>Send it to Howard, He could put it in his Ford (if it is a variable speed) and not have to worry about his engine or transmission.

Re: use for an old router motor?

#3

Do you own a small boat?

Ken Oakley-Sunny St. Cloud, Fla.

>

Re: use for an old router motor?

#4

Re: use for an old router motor?

Barry Irby

>It might fit into one of the router lift plates if you wanted to buy one, but that makes about as much sense as buying a diamond incrusted 24K band for ten dollar watch.

Re: use for an old router motor?

#6

Dale Lenz

Re: use for an old router motor?

Dale Lenz

>Might use this opportunity to build/make/devise a pin router? just a thought.

Good luck,

Dale

Re: use for an old router motor?

#7

make a jig for your lathe. *LINK*

John Lucas

>Check out the link below. I used a trim router but I plan to hook up my Porter Cable full size in the very near future. I've had a lot of fun doing indexed cuts on all sorts of turnings, not just spindles.


http://www.cumberlandwoodturners.com/tips/fluting_jig_for_the_lathe.pdf

Re: use for an old router motor?

#8

Re: use for an old router motor?

wes bischel

>Dedicate it to a dovetail jig. Set the height and glue it in place!

Wes

Re: use for an old router motor?

#9

Great Idea, John

George@Colonel's Workshop-Havertown PA

>