Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

vacuum for ROS

Posts

vacuum for ROS

#1

vacuum for ROS

Jim F.

>I'm looking for a vacuum to use with my DeWalt random orbit sander. My dust collector is rated at 14 amps. and shop vac. at 11 amps. They are both way too much for a 2 amp. sander and way too noisy. I'm looking for a samll, quiet vacuum with at least a 1 or .5 micron filter. I've seen the ones that are $300+ but there must be something out there much less costly that can be adapted to this job.

Re: vacuum for ROS

#2

Re: vacuum for ROS

Larry Marker in Alabama

>I don't know why you think your vac and dust collectors are overkill. I use an old Shop Vac connected to my ROS and the exhaust of the SHop Vac is connected to my central DC. THe vac gives me the velocity needed through the sander and the DC helps keep the static pressure up on the vac and also gives me another stage of filtration before the aire gets exhausted back into th eshop.

This lash up IS noisy, so I wear hearing protection when I'm sanding.

Larry

Re: vacuum for ROS

#3

Re: vacuum for ROS

Paul Dwight

>I have a year-old ShopVac that's from their new lineup of quieter machines. They still sell the old noisy ones, too, so you have to be careful about which one you're seeing. Mine works very well and it is MUCH quieter than older models. One micron cartridge filters are available. ShopVac also sells filter bags, which I highly recommend, especially for sanding -- otherwise the fine sanding dust will quickly clog the filter.

The ShopVac would be even better if it had an auto-start switch. I bought a $20 switch at Sears that does the same thing, though not quite as elegantly.

When I bought the ShopVac it came with a 2-1/2" hose. For sanding, you'd probably need to buy a smaller hose.

I understand Ridgid also has a new line of quieter vacs, but I have no experience with them. Since you're going to be using this with a sander, I would consider the Ridgid only if they sell filter bags for it -- there's no other efficient way to keep the filter from clogging.

Hope this helps. -- Paul

Re: vacuum for ROS

#4

Overkill

Jim F.

>When I'm using the DC or shop vac those high amp high noise macnines are running for only a few minutes at a time with an equally noisy tool (saw, planer, jointer)but sanding is often up to 15 min. to a half hour at a time. Also unless I put a secondary opening in the vacuun hose the excess vacuum between the sander and the wood is so great that it will slow the sander and also make it hard to slide over the surface. Overkill (for me)is using 14 amps of vacuum to remove 2 amps of sawdust. It may be that while sanding I have too much idle time to think up unnecessaty problems. :>)

Re: vacuum for ROS

#5

Re: vacuum for ROS

Jim F.

>Thanks Paul, That is the kind of info that I was looking for.

Jim