Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

OT - Utility trailer problems

Posts

OT - Utility trailer problems

#1

OT - Utility trailer problems

Tim Caley - North Little Rock

>I have a small 4x6' utility to use for hauling stuff around. One of the tires keeps going flat and I can't get the wheel off because the lug nuts are rusted on. I've tried taking the wheel of with the trailer empty and the wheel just spins. I've tried it with the trailer full of a couple hundred pounds of mulch. I can't get them to budge.

Any ideas how to get the lug nuts off?

Re: OT - Utility trailer problems

#2

Re: OT - Utility trailer problems

Chuck W

>Have you tried "loosenut" or "liquid wrench" to dissolve the rust? You might try to apply heat to the nuts. A small plumbers propane torch should be adequate for that.

Re: OT - Utility trailer problems

#3

Re: OT - Utility trailer problems

Gary Evans Tallassee, TN

>Hi Tim,

Do you have any friends who are car mechanics? A good 1/2" drive impact will either take off the nuts or break the studs. Either way, you'll have the wheel off. Broken studs are not hard to replace.

Gary

Re: OT - Utility trailer problems

#4

Re: OT - Utility trailer problems

Howard Acheson

>Go to a tire store. The can hit it with their impact wrench. That'll get it off generally. Have them loosen all the lugs and then get some grease and lub them up.

Re: OT - Utility trailer problems

#5

Re: OT - Utility trailer problems

George@Colonel's Workshop-Havertown PA

>Hello Tom,

I had that kind of problem with a very old car my daughter was driving--and left by the side of the road. Once my #1 son &I found it, we realized we couldn't get the tire off. Fortunately, I had a piece of pipe destined for a 3/4" Pony Clamp, and it fit over the end of my star wrench, giving me five feet of extra leverage. We got all the nuts removed and lubricated the studs with the engine dip stick.

George

George

Re: OT - Utility trailer problems

#6

PB Blaster, good soaking, and...

Dave Morris

>... then use an impact wrench. That'll save you from breaking the stud off. You can get PB Blaster at most auto parts stores. GREAT stuff for breaking loose stuck nuts and bolts.

Dave

Re: OT - Utility trailer problems

#7

Re: PB Blaster, good soaking, and...

Jerry Burns

>I second the bp blaster and inpack

Re: OT - Utility trailer problems

#8

Re: OT - Utility trailer problems

Gene Gauss

>I've been successful cooking the lug nut up good with a propane torch and a piece of pipe to get some more leverage on a 1/2" socket wrench flex handle. Once you get them off, brush them off well with a wire brush and put a liberal coat of Never-Sieze on before you put them back on. Gene Gauss

Re: OT - Utility trailer problems

#9

easy solution

Bill Tindal, E.TN

>I have had this problem many times. Your local tire store will have a 300 ft lb impact wrench and it will remove the nuts with ease.

Alternatively, put some of the green tire fixing junk in the tire and it will seal the leak.

Re: OT - Utility trailer problems

#10

PS

Bill Tindal, E.TN

>put some penetrating oil on the nuts before visiting the tire store. It will help them get the nuts loose.

Re: OT - Utility trailer problems

#11

Re: PB Blaster, EVEN BETTER

Kneale Brownson in Northern MI

>Something you're more likely to have around is automatic transmission oil. Mix a few drops with a few drops of acetone and apply to the studs. Someone recently did a test of penetrating oils and found a home-brew of 50-50 acetone and ATF required less than half the torque to loosen something stuck than the most effective commercial penetrating oil, which was Kroil. PB Blaster came in fourth and required four times the torque.

Re: OT - Utility trailer problems

#12

No Kiddin'? ... COOL!

Dave Morris

>Gunna have to give that a try on one of my next restos. Got a few "hunnerd-year" bolts that feel pretty tight on an ooooold planer, and I REALLY don't want to snap them off in place. I'm betting the Dexron and Type F manufacturers never imagined this particular use for their products, since pouring a 50/50 mixture of acetone and tranny fluid into your transmission's filler tube isn't exactly a cure for any ills it may be experiencing. ;-)

Dave

Re: OT - Utility trailer problems

#13

Re: OT - Utility trailer problems

Tim Caley - North Little Rock

>I'm back after the long weekend. Thanks every one for posting for posting these suggestions. I will give them a try.