Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Filling knot hole in counter top

Posts

Filling knot hole in counter top

#1

Filling knot hole in counter top

Jerry Burns

>I have built two counter tops out of hard Maple. Trying to keep the rustic look I left the knot hole in the boards when I did the glue up I want to keep the holes but fill them with some thing that I can put polyurethane over and still see the hole SWMOB realy likes the look and requested the holed stay and been seen. The hole sizes are 1" and .75" about

Thank you

ps Cherry bread boards will be fitted on the ends

Re: Filling knot hole in counter top

#2

JL

Re: Epoxy...

JL

>or cyano acrylate adhesive mixed with something (brass key shavings, coffee grounds, etc.). Do you want it to stand out?

Re: Filling knot hole in counter top

#3

Dale Lenz

Re: Filling knot hole in counter top

Dale Lenz

>Jerry,

I use epoxy and mix in black power, see pic below. I'll take the 5 min Devcon epoxy( $2 at WallyWorld) in the syngines(sp) thingys and mix a pinch of blacken saw-dust, pour into defect and leave slightly proud. Let dry, a few hours, file, sand or scrape level. Works well under all finishes I have thrown at it, oil, varnish and lacquer. My blacken sawdust is: oak, walnut or cherry any hardwood with a high tannin content. Throw some iron filings in with the sawdust, wet and let dry. The iron and tannin in the wood will blacken within an hour or less. Could probably grind up some charcoal(?).


img

Re: Filling knot hole in counter top

#4

Re: Filling knot hole in counter top

Larry Clinton At Frankfort (Central)., Indiana

>I am helping my son trim out his house in White oak. We had some beautiful figured boards - one had a fairly large knot right in the center. I didn't have the black Rit dye I would normally use to make the epoxy black so as an experiment, I colored the bottom & sides of the knot hole with India Ink and filled the hole with clear Devcon 10 minute epoxy. When the epoxy had set for about an hour I scraped and sanded it flat. After sanding with 220 grit, we stained the board and wiped the stain (removing all from the epoxy). Then coated the trim with orange shellac. The knot hole looked so neat, my son used it as a top trim board over a wide doorway opening into the kitchen. The epoxy stayed transparent and the hole looks like your looking into a pool of water.