Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

OT- HDPE & UHMW plastic supplier *LINK*

Posts

OT- HDPE & UHMW plastic supplier *LINK*

#1

OT- HDPE & UHMW plastic supplier *LINK*

Ray Carson in Lawrenceville, NJ

>Hello,

For those who fabricate their own jigs or inlay cutting boards with plastic, or maybe need a slick guide service.........whatever.

I found a supplier of quality Phenolic ▪ Acrylic ▪ Polyethylene ▪ Acetal ▪ Delrin ▪ PVC ▪ Nylon ▪ plastic welding Rods and plastic welders. Unless your into heavy fabrication the welders are quite expensive.

Anyway, I needed some HDPE for something and found this company easy to deal with and it seemed as though the "techs" knew their stuff.

No affiliation with this company. Stumbled upon it using a search engine.

Just thought I'd pass this information onto my friends.

Ray


U.S. Plastics Corp.

Re: OT- HDPE & UHMW plastic supplier *LINK*

#2

Thanks!

Tony - Memphis

>I think I have bought some UHMW strips from them before. Always nice to hear of a good resource.

Tony

Re: OT- HDPE & UHMW plastic supplier *LINK*

#3

Very useful. Thanks.

David Barnett - SW Florida

>They carry just what I need to turn some cold halogen fiberoptic microscope fittings.

Re: OT- HDPE & UHMW plastic supplier *LINK*

#4

Care to elaborate? :-)

Ellis Walentine, Host

>

Re: OT- HDPE & UHMW plastic supplier *LINK*

#5

Re: Care to elaborate? :-) Honestly Ellis...

Ray Carson in Lawrenceville, NJ

>don't you know what a cold halogen fiberoptic microscope fitting is? It's the opposite of a hot halogen fiberoptic microscope fitting.

I thought you were smarter than that. :-)

My use for the HDPE (High Density Polyethylene) was for an idea I had for my Dad's boat. The transom on the boat is cut out really low for the outboard motor. The water tends to accumulate rather quickly at the stern when backtrolling. It washes over the cutout on the transom. It's perfectly safe and the boat company says it's not an issue. In fact the entire boat can be cut full of holes and still float. I think it's a poor design myself but hey, what do I know.

I figured if we built a false "bulkhead" just in front of the bilge pump hatch, then all the water would stay between the new bulkhead and the transom. HDPE seemed like a inexpensive solution.

U.S. Plastics also had some HDPE "C" channel that will serve as a guide slot to hold it in place.

Now onto buildnig my "fly mack manipulator with the fetsor valve attachment."

Ray