Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Finish carpentry question

Posts

Finish carpentry question

#1

Finish carpentry question

Bill Tindal, E.TN

>I have some short pieces of base board to install and there is no framing behind these areas, only drywall. So, how does one attach baseboard where these is nothing but drywall behind it, or at most a stud at one end?

The walls are painted, so that eliminates any adhesive that requires a porous surface, eg yellow glue.

Re: Finish carpentry question

#2

Liquid Nails

Keith Newton

>

Re: Finish carpentry question

#3

Re: Finish carpentry question

Mark Mandell - Gone Round In Jersey

>Couple of dabs of hot-melt glue, hold for 20 sec., and yer done.

|;-}}

Re: Finish carpentry question

#4

Another option...

Jason Roehl in Mulberry, IN

>If you are using pneumatic trim nailers, you can shoot two nails close together in an 'X'. You should also be able to shoot into the bottom plate of the stud wall if there is one.

Jason

Re: Finish carpentry question

#5

Re: Finish carpentry question

Rob Sandow

>Bill,

Remove a few short rectangular shapes of drywall behind where the baseboard will be, a few inches long and about 1" tall. Cut some 1"x1/2" strips of scrap wood about 8 or 9" long and insert them through the holes you cut in the drywall. Use construction adhehesive to hold them to the back of the drywall. Then place another piece of wood across the front, drill some pilot holes, and use drywall screws to hold the boards in the back in place until the construction adhesive dries. Once dry, rwmovw the front boards and use a brad gun to nail the baseboard in place.

I have even used this technique to place an artificial "stud" where there was none, to secure drywall into odd places. It works well.

Rob

Re: Finish carpentry question

#6

Re: Finish carpentry question

DB

>What is holding and supporting the drywall? The drywall is not very strong on its own. You need something (studs, top plate, or bottom plate) behind the wallboard for support.

Re: Finish carpentry question

#7

With the wisdom of WC . . .

s.mackay@worldnet.att.net

>I finnished up this weekend. I destroyed six small pieces before I asked for guidance here. You can lead a horse, yadda, yadda. Once you get the part to fit ( no mean feat ! ) drill a TINY pilot hole, apply liquid nail and install with a 1" brad. When I did'nt use the brad the part tended to drift a bit. LOML got home and was very pleased ! Thanks WC !


img

Re: Finish carpentry question

#8

Re: With the wisdom of WC . . .

s.mackay@worldnet.att.net

>

Re: Finish carpentry question

#9

Re: With the wisdom of WC . . . 

s.mackay@worldnet.att.net

>


img

Re: Finish carpentry question

#10

thanks to all; installation complete

Bill Tindal, E.TN

>