Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Help, I'm A Rock

Posts

Help, I'm A Rock

#1

Help, I'm A Rock

Mark Mandell - Gone Round In Jersey

>In the last stages of a walnut kitchen bar-height table which uses Dark Emperadore marble tile (12x12) for the top. Have filled the joints with colored epoxy, and have cleaned off the excess resin with solvent. I still have a few streaks and a few errant scratches in the stone that I want to bring up to an even polish. Anyone here done this and if so, what did you use to clean up the stone surface?

Thanks.

mm

Re: Help, I'm A Rock

#2

JL

Re: Help, I'm A Rock

JL

>I haven't done marble, only granite tile pieces. I used a slurry of aluminum oxide and water in decreasing grit sizes (80 - 600). You could probably use rubbing compound also.

Re: Help, I'm A Rock

#3

Re: Compound

Mark Mandell - Gone Round In Jersey

>I have Meguire's, but I'm a bit concerned about defeating the factory sealer applied to the tiles. Suppose I'll just give it a shot and hope for the best.

Thanks