Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

burning bore box bit revisited

Posts

burning bore box bit revisited

#1

burning bore box bit revisited

brad kansas

>Well, I replaced the 27k/rpm Porter Cable cable router with a Porter Cable variable speed in my table and turned the speed down to 12K. Following Ellis and one other responder's information regarding the burning point being at the point on the bit where it curves up to 90 degrees, I reduced the depth of the cut and presto, only insignificant very slight browning. Discoloration occured at the slower speed at progessively deeper cuts, but not the dark brown to black as with the faster router - yet, still unacceptable. Therefore, slow router speed and shallow depth interact to minimize discoloration. Moving the material very slowly across the bit promotes burn but normal safe movement does not. Running a router at 12k isn't nearly as scary as 27k. Thanks for all the earlier tips.

Brad

Re: burning bore box bit revisited

#2

"core"

brad kansas

>

Re: burning bore box bit revisited

#3

Questions

Lee Schierer - McKean, PA

>If you do the routing in progressive steps do you still get the burning?

Might we inquire as to the brand of bit? I have a Freud 3/8 dia core box bit and it doesn't tend to burn unless I leave it in one spot for 30+ seconds. However, I've never tried a full depth cut in one pass with it.

Lee

Re: burning bore box bit revisited

#4

Re: Questions

brad kansas

>Hi Lee

I've never tried progressively deeper cuts. I'd be afraid of not perfectly aligning subsequent cuts.

The bit is a 1 1/4" Woodcraft and I'm fluting quarter sawn white oak. What kind of wood are you fluting? What speed is your router?

Brad

Re: burning bore box bit revisited

#5

use spacer boards with your fence

Robin Corell in Atascadero, CA

>Using a series of spacer boards rather than adjusting the fence on your router table will allow you to use the different depth stops on your router so you can take progressive cuts if you are using a plunge router. If you are not using a plunge router it just takes a bit longer but the principle is the same, just dont move your fence when adjusting the depth of cut.

Robin Corell

Re: burning bore box bit revisited

#6

Re: burning bore box bit revisited

Barry Irby

>I responded to your earlier post about the burning, suggesting using the Dremel Buffs to clean it up. OTOH, if you can avoid the burning altogether, that's better.

My bit is an 1 1/2" and I sued it to make an "egg Carton" tray to go in the top of a jewelry box. I had to set up a series of spacers to help SECURE the router before I plunged it. I tried to do it pretty much free hand. NOT A GOOD IDEA. Big bit, powerful router. Be careful.