Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Convertable dressing table

Posts

Convertable dressing table

#1

Convertable dressing table

Lee Schierer - McKean, PA

>My son and his wife are expecting their first child later this month. A while back we offered to make them at least part of the baby furniture for the soon to be nursery. After a bit of searching to see something they like they settled on a design and we worked out the details. They wanted the top to be removeable so that they could use the dressing table later as just a dresser without the changing pad rails. There was also some discussion about making it into an hutch type dresser or to have a bookshelf unit on top. I came up with a way to have the chaging pad located on the top and have rails on 3 sides so it wouldn't slide off and then remove a false top and have a finished top under it that would be completely flat without any holes.

The dressing table is made of solid poplar and painted with a white enamel paint to coordinate with the decor in the rest of the room.


img

Re: Convertable dressing table

#2

I like it, Lee

Ellis Walentine, Host

>This piece has a Shaker simplicity to it, not that they made a lot of changing tables. :-) I'm sure your son and his wife are tickled pink, or should that be blue?

Good luck to the new parents.

Ellis

Re: Convertable dressing table

#3

Re: Convertable dressing table

Dan Donaldson

>Could you post details on how you did the removable top with no holes? Nice design.

Re: Convertable dressing table

#4

Re: Convertable dressing table

Thomas Skaggs, Foothills of Mount Level

>Lee,

Perfect piece for a nursery! It will get a lot of use for many years. Nice job!

Tom

Re: Convertable dressing table

#5

Convertable top details

Lee Schierer - McKean, PA

>The top is a piece of 1/4" plywood (I used 1/4" luan underlayment). It is sized 1-3/8" bigger in length and width than the dresser top. Around the edge of the plywood I attached pieces of 3/4" x 1-1/4 poplar so the 3/4" side ws against the plywood to form a border. I routed the edge of the plywood and border pieces so it matches the routing on the base. Then I made the three rail pieces. These were screwed together to form a U-shape and then attached to the top side of the plywood by woodscrews up through the plywood from the underside. Once the whole thing ws assembled and sanded, I painted the visible areas with the finsih color. The hidden areas wer sealed with water based polyurethane (I was running short on tinted paint and I wanted something that wouldn't tend to stick to the painted top it would rest upon.)

Hope this answers your questions.

Lee

Re: Convertable dressing table

#6

personal experience

Bill Tindal, E.TN

>I built one of these, not nearly as refined and nice as yours, for our first born. Last week she had her first born and requested we send the table to her. So, you may expect this fine piece to be handed down for generations, and deservedly so. You may want to consider putting casters on it. We found this addition useful.

Re: Convertable dressing table

#7

Re: Convertable dressing table

George@Colonel's Workshop-Havefrtown PA

>Good Afternoon Lee,

You did a characteristically great job on that one, Lee. I'm sure your son and his wife are also producing something of equal or superior quality. They must be like our #2 son and his wife. They never found out the sex by ultrasound, preferring to be surprised. Good for them. Early congratulations, Pop-pop. :<)

George

Re: Convertable dressing table

#8

Re: Convertable dressing table

Pete Stahl

>Very nicely done. Should last your grandchild a long time.