Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Irridescent finishing with Pearl Ex? *LINK*

Posts

Irridescent finishing with Pearl Ex? *LINK*

#1

Irridescent finishing with Pearl Ex? *LINK*

GolfSteve in Calgary

>I want to experiment with Pearl Ex powders to see what kind of shimmering or irridescent effects I might be able to get on wood. Pearl Ex is a brand of powdered pigments. I bought some of their pearlescent pigments (micropearl, interference red, and some copper) to try out.

I started experimenting with this stuff but it might take me forever to figure out a magic formula that someone else has already developed. The effect I'm looking for is a slight shimmer to the finish, or that slight colour shift you get when looking at a Mallard's neck, but I want the natural wood grain to be predominant. I don't want a "metallic paint" look.

What I've tried so far is putting a small amount of Micropearl into the second coat of a multi-coat coat waterbased laquer finish on cherry. When polished up it looks good, but the micropearl perhaps muddies up the finish more than creating shimmer. When the light hits it you can see the pearly bits and there is a bit of irridescence as the light moves across it. It's not too bad, but not what I'm looking for - I'm looking for more of the quilted maple type chatoyance. I haven't tried the "Interference Red", and I perhaps don't understand colour theory and how the interference pigments are supposed to work well enough.

I'm currently refinishing a walnut coffee table that I want to try this finish on. Perhaps this type of finish might work better on a light wood?

Any advice from the experts?


Some info on pearl ex

Re: Irridescent finishing with Pearl Ex? *LINK*

#2

Some photos of the test boards (big pics)

GolfSteve in Calgary

>Overhead of the three boards (top is plywood for a mobile base, then curly maple, and cherry.) All three boards have their left side rubbed out with rottenstone, the middle rubbed out with steel wool, and the right side polished with Mezerna paste.

The micropearls seemed to bring some life into the plywood grain...much more so than on the curly maple or cherry.


Here's two closeup's of the plywood showing a bit of the visible micropearls on the glossy section:



And a shot on the section rubbed out with steel wool. In this photo you can see a bit of how the micropearl actually muddies things up a bit instead of making things irridescent.


A shot on the cherry...I went quite lite on the micropearls, but the rubbing out shows up nicely. The Target ultima spray lacquer looks a bit plasticy to my eye, but perhaps I put in on too thick?


Sorry about the picture size...when I tried to resize it seemed like the micropearls disappeared from the pictures, so I just tried to crop out some of the interesting bits from the original photos.

Re: Irridescent finishing with Pearl Ex? *LINK*

#3

Re: Irridescent finishing with Pearl Ex?

Clint Searl, at the base of Haycock Mtn

>I use pearl finishes whwnever I can, either as an accent or main event. Here's an example where I've accented the edge of the flitch with a copper toned pearl and door panels of cork veneer done in a gold pearl. The pearls are in a paste that mixes with solvent lacquer. I also mix different pearl powder pigments into clear lacquer to go over base colors for interesting effects. I get mine from Kremer.

Clint


img