Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Sanding belt splice?

Posts

Sanding belt splice?

#1

Sanding belt splice?

Ken Grunke from SW WI

>A while back I purchased rolls of sanding belt stock at a surplus store, thinking I could make my own sanding belts and save a little money plus time over waiting for an order to ship. I'm still looking for the optimum splice material and adhesive. The manufacturers use what looks like nylon strapping tape but the fibers run in two, sometimes three directions.

Adhesive shouldn't be hard to find, a heat-resistant contact cement for sanding pads should work but I can't find that kind of tape anywhere.

My latest fiasco involved iron-on patch material which looked promising but didn't last more than a second.

Any bright ideas out there?

Re: Sanding belt splice?

#2

Re: Sanding belt splice?

jim holman

>I would recommend you give it up as a bad job. My wife retired this year after working with abrasives for 20 years and some of her expertise rubbed off. The splice you are referring to is a butt splice. The tape and adhesive are sold to belt manufacturers usually as a unit. The adhesive is shipped on dry ice and has a short shelf life. The tape, belt and adhesive are pressed on a heated press to activate and set the adhesive. Belts can also be skived, a small amount removed from each side of the joint, overlapped and glued to each other. Again the glue is the hard spot. Finding a glue that will not release under the heat caused by sanding friction in a tough one. I have tried over the years with just about all available glues. I gave it up as a bad job.

Re: Sanding belt splice?

#3

Re: Sanding belt splice?

Barry Irby

>What type of abrasive do you have? Maybe it would work on somebody's Performax type sander. (Me, me..I have one!!) Maybe if the splice does not work out for you, you could horse trade. The drum sanders use a strip of cloth backed abrasive, but it is not spliced.

Re: Sanding belt splice?

#4

Re: Sanding belt splice?

Ken Grunke from SW WI

>Barry, it's Norton sanding belt cloth, 2 1/2" wide, 120 grit. I'll probably hang on to it regardless, it's good for sanding paint-grade spindles on the lathe if nothing else.

Re: Sanding belt splice?

#5

Re: Sanding belt splice?

Ken Grunke from SW WI

>Interesting. Not very encouraging, but interesting :)

Thanks, Jim.

Re: Sanding belt splice?

#6

Re: Sanding belt splice?

Thad

>My grandfather-in-law does this with Gorilla glue...not sure exactly how though. Good luck.

~ Thad