Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Cleaning up the end grain on a raised panel

Posts

Cleaning up the end grain on a raised panel

#1

Cleaning up the end grain on a raised panel

lee beeden

>I've made raised panels a few times now; using my vertical router bit and on the table saw. The last set were done on the table saw and i had a difficult job cleaning up the end grain. Sanding with the grain is no problem, but i just haven't yet figured out a good technique for cleaning the end grain so that it has that same crisp look. Any tips greatly appreciated.

Lee

Re: Cleaning up the end grain on a raised panel

#2

Re: Cleaning up the end grain on a raised panel

Ed Mulligan, Cape Cod

>lee -

In the same situation I made a scratch stock with the desired profile. I also made a sanding block with the same profile with a fence to register against the panel edges. The fence keeps the block from going in too far and dubbing the panel arris.

The scratch stock is used for rapid stock removal. You might not need it for your panels.

Ed

Re: Cleaning up the end grain on a raised panel

#3

Re: Cleaning up the end grain on a raised panel

Charles Sharp

>I'm not sure if this will help you or not.

I took a piece of foam pipe insulation, put a 6" pipe nipple in it and wrap my sandpaper around it.

I was sanding a European Beech raised panel last night and was wishing there was an easier way to do this.

How do they do this in commerical door shops?

Re: Cleaning up the end grain on a raised panel

#4

Re: Cleaning up the end grain on a raised panel

Larry Clinton At Frankfort (Central)., Indiana

>This is the one place I actually use the Dremel "profile sander" I bought a few years ago (I bought it on clearance when a lumberyard was going out of business so didn't pay much). Like most I found it to be of little use in most projects. But it sure worked well when I refinished our kitchen cabinets and also does well for sanding the profile on panels. At the same closeout I bought a box of the Porter cable profiles - can't tell you which ones I use but I can leave a sharp crisp edge and really smooth out the end grain on the panels. I also used it on the edges of the flat plywood doors on my shop cabinets. I routed a profile on the edge of 1/2 Oak plywood to make my doors and the sander did pretty well finishing the edges - had to fill some voids with CA and sawdust - then sanded - ok for shop cabinets.