Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Square the hole or round the peg?

Posts

Square the hole or round the peg?

#1

Square the hole or round the peg?

Gary Evans Tallassee, TN

>I'm working on the mortices for my mailbox post. Given the restrictions of my tools, they've been drilled to 2 1/4" with a 1" forstner bit. Now that I'm almost ready to fit the tenons, I'm facing the question of which is better, square the corners of the mortice or round the corners of the tenon.

I know which way I'm going, but I wondered if there were compelling arguments for using one method over the other?

Thanks,

Gary

Re: Square the hole or round the peg?

#2

Re: Square the hole or round the peg?

Thomas Skaggs, Foothills of Mount Level

>Tenons are structurals elements and their size (mass) should be in keeping with the load or stress they will bear. Rounding the corners will lessen the mass of the tenons. I would probably suggest you square the mortises with a bench chisel.

Tom

Re: Square the hole or round the peg?

#3

Re: Square the hole or round the peg?

Gary Evans Tallassee, TN

>Thanks Tom,

Naturally I already had the corners rounded by the time I read your post. The question was sort of rhetorical. I thought about your very point before I started rounding, but decided that I really wasn't losing that much wood.

The spars that I'm attaching to the post only have to hold up a mailbox, so I think I have a pretty good CYA factor built in.

Thanks again,

Gary