Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Design question - using spalted maple

Posts

Design question - using spalted maple

#1

Design question - using spalted maple

Stephen Kirk in Quakertown PA

>I rescued some spalted maybe from a potential firey state. Amazing, no one wanted it. I'm going to use it to make a Nantucket style bench which will be a coffee table. This style of bench has two legs, a top, a lower shelf and two rails under the top. I originally thought I'd make everything out of the spalted maple, but now I'm thinking that may be just too much spalting. I'm wondering about how I should incorporate another wood, for contrast, perhaps some clear maple. This stuff has a ton of figure.

Some ideas:

1) spalted top and shelf, clear legs and rails

2) spalted top and legs, clear rails and shelf

3) spalted top, rails and shelf, clear legs

Anyone have a good sense for design and balance? I'm leaning towards #1 or #3 myself.

Re: Design question - using spalted maple

#2

Re: Design question - using spalted maple

Tom Dunlap in Atlanta

>I would be uncomfortable using the spalted wood for the legs. Legs, to my eyes, are supposed to be strong and sturdy. The spalting, even though there is little to no wood strength loss, would impart a feeling of weakness to me.

Tmo

Re: Design question - using spalted maple

#3

Re: Design question - using spalted maple

Clint Searl, at the base of Haycock Mtn

>I think spalted wood looks best when contrasted with something less figured, per the example below. I vote for top only.

Clint


img

Re: Design question - using spalted maple

#4

Re: Design question - using spalted maple

Paul Dwight

>I agree with Clint -- I would use the spalted maple for the top, only. I would probably build the rest of the table out of cherry. Use dye stains to push the cherry a little to the nut-brown side of the spectrum and it will look fantastic against the cream and tan tones of the spalted maple.

Good luck! -- Paul

Re: Design question - using spalted maple

#5

Re: Design question - using spalted maple

Stephen Kirk in Quakertown PA

>I think I agree with the posts here. And seeing Clints very pretty picture kinda drove that home. I'm still thinking of the top and maybe the middle shelf (it will be quite visible), and then using something more contrasting for the legs. I have lots of red oak, and I think even a bit of cherry around.

Re: Design question - using spalted maple

#6

Re: Design question - using spalted maple

Clay Foster

>Stephen,

I've used a lot of spalted wood in furniture. If you've got a good strong design, it doesn't matter what the mix of spalted/nonspalted wood is. If the design is weak, it doesn't matter what the mix of spalted/nonspalted wood is.