Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

O T socket for rounded bolt head?

Posts

O T socket for rounded bolt head?

#1

O T socket for rounded bolt head?

Paul Waddle

>Are there any specailty sockets that will grip rounded bolt heads?? As in removing the motor from a lawn mower. The motor is held to the frame by (3) 3/8-16 bolts and the heads were rusty and rounded when I tried to remove them. I seem to remember seeing such for a hand wrench but not for a socket. thks,pw

Re: O T socket for rounded bolt head?

#2

Re: O T socket for rounded bolt head?

Jason Roehl in Mulberry, IN

>Craftsman has some "Bolt-Out" sockets that have a steep, reverse thread that is designed to cut into and tighten onto the bolt head as you "lefty-loosy". Another option is Metrinch tools; they are designed to grip the flats instead of the corners.

If the bolt is frozen (rusted) on, a torch and candle wax can free it, or soak it with PB Blaster several times over the course of a couple days.

Jason

Re: O T socket for rounded bolt head?

#3

Re: O T socket for rounded bolt head?

Paul Waddle

>Thanks for the info,I'm emailing you for more elaboration. pw

Re: O T socket for rounded bolt head?

#4

They work very well

Larry Marker in Alabama

>Those Craftsman bolt remoevers work very well. I tore down a small engine recently and they saved my bacon. They don't even tear up the bolt head when you use thwm. Sears sells a set with the most common sizes included and several empty places for others and they also sell an upgrade set that fills out the rest.

Larry

Re: O T socket for rounded bolt head?

#5

I've used a metric socket a hair smaller...

John in New Mexico

>Hammer it on, it'll either break the bolt loose or torque the head off. The socket should be considered disposible of course.

John

Re: O T socket for rounded bolt head?

#6

Re: O T socket for rounded bolt head?

Jim Swank

>Too late for these bolts, but an illustration of why 6 point sockets are preferable to 12 point.

Re: O T socket for rounded bolt head?

#7

Re: O T socket for rounded bolt head?

Keith Newton

>You may end up having to use a right-angle grinder, to just grind the head off, then put new bolts back in when you finish your repair.

If you can't get at the damaged head on the top side, see if you can get at the nuts on the bottom, and grind / cut them off under there.

Re: O T socket for rounded bolt head?

#8

Re: O T socket for rounded bolt head?

Paul Waddle

>Hi,just what I had to do. It was a uneasy feeling seeing those sparks fly in the close proximity of the gas tank,but I ground the heads off. This still left 3-16 studs screwed into the bottom of the mower. This ultimately resulted in broken drill bits, a broken tap and finally wallowed out holes-p poor job for lack of proper tools. I susequently used 5/16-18 bolts to hold motor back on another frame. Did anyone else have a similar feisco. Glad I don't work on my truck! pw ps,I'd like to say my woodwork is somewaht better butt....

Re: O T socket for rounded bolt head?

#9

Dale Lenz

Re: O T socket for rounded bolt head?

Dale Lenz

>Paul,

If the motor mounting bolts goes through the mower deck, is there enough bolt to grab with a pair of vise-grips? If not sounds like a job for an easy-out or a trip to the machine shop...Good luck

Re: O T socket for rounded bolt head?

#10

Vice Grips & new bolts with ny-loc nuts

Pete LaBelle

>