Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Mahogany Chest

Posts

Mahogany Chest

#1

Mahogany Chest

MikefromTn

>Replica from mahogany shipping crates. 24x36x27, before hardware. This is my sixth one of these. You would think I should have the top figured out by now. Does anyone know the formula for figuring out the angle of the cut to match the angle of the arch on the top?


img

Re: Mahogany Chest

#2

JL

Re: Pretty chest...

JL

>have you considered a "canoe joint" bit and using a router on the edges? That way you don't have to worry about any angles... Just a thought.

Re: Mahogany Chest

#3

Re: Mahogany Chest

Clint Searl, at the base of Haycock Mtn

>What portion of a full circle does the top arc represent? For example, assume 1/6. Divide 360 by 6. 360/6=60 Now, how many staves? Assume 8. Divide 60 by 8. 60/8=7.5 Subract 7.5 from 180. 180-7.5=172.5 Divide 172.5 by 2. 172.5/2=86.25 This is the angle of the stave edge, so tilt the blade 90-86.25=3.75 degrees. I think.

Clint

Re: Mahogany Chest

#4

Re: Mahogany Chest

Dan Bay

>Just a note that may be in play considering the calulation; since the hoizontal plane does not bisect the center of the circle, I believe that you would end up with not flat or non-hoizontal bevels on the ends of your arch. The amount of bevel error would be in relation to how far from a true half circle your arch is.

There is a formula that acounts for this off axis section of a circle but it escapes me at this hour. It uses the sagital depth, radius, and cord length to determine the important bits.

Re: Mahogany Chest

#5

Ellis Walentine

Another way to figure it

Ellis Walentine

>If you know the radius of the arched top and the width of the boards you are coopering, a couple quick strokes of a trig calculator will give you the correct bevel angle. Take half the board width, divide it by the outside radius of the top, find the inverse tangent (tan-1) and subtract the resulting angle (a) from 90� to get the cutting angle. Actually, since tablesaw angle scales indicate degrees off 90, angle a becomes the cutting angle. Use an accurate protractor to set your bevel gauge, and test your saw setting on scrap. Works for me.

Ellis Walentine, Host


img

Re: Mahogany Chest

#6

Re: Another way to figure it

MikefromTn.

>Thanks everyone. I've got a workable idea and the pic. made it click for me Ellis. Thanks again