Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Festool DOMINO - illustrated example *LINK*

Posts

Festool DOMINO - illustrated example *LINK*

#1

Festool DOMINO - illustrated example *LINK*

charlie belden

>I've done two more bonsai tables - this time using the

DOMINO instead of the TREND M&T Jig and a router. The

difference in the time required to set up and cut the

mortises was very pleasantly surprising - and so much

easier - with a lot less mental gymnastics. Better than

one quarter of the time - no mental gymnastics - and

no headache!

The leg to apron design is simple - a mortise on

both ends of each apron part, corresponding mortises

on two faces of each leg. The front of the apron is

stepped back about 1/4" and the mortises in the aprons

are "cheated" towards the front to allow for a groove

on the back for a Z-clip to hold the top onto the apron/

legs.

The "step back" could complicate things a bit, as would

the "cheat towards the front of the apron". The DOMINO

simplified things significantly.

The best part is - NO LAYOUT LINES and the absolute minimum

set up time.

I hope the stuff at the following url conveys just one

example of the value of the DOMINO to furniture making

- at least at the hobbiest / amateur/ one man shop level.

This is getting interestinger and interestinger.

More to come.

charlie b


Illustrated Process Example - leg to apron