Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

OT - getting into locked car trunks

Posts

OT - getting into locked car trunks

#1

OT - getting into locked car trunks

Carol - Strawberry, AZ

>My friend has a Chevy Lumina. We have tried to get into her trunk. The key won't turn. Here is where we are at this point:

She swears it is the right key!

We've tried WD-40, liquid graphite, and silicone.

We tried to remove the back seat. There is some sort of cage behind that severely restricting the smallest of us to get in there and unlock it from that angle.

She is ready to drill it out, but we don't know how to do that.

We are all poor a church mice, so a locksmith is out of budget.

The car is a beater, so baling wire to hold it closed later is OK with her.

It getting close to time to move off campus. She needs her trunk.

I do have a full selection of drill bits and a cordless driver at hand. How DO you drill out a car lock?

Suggestions?

Thanks.

Re: OT - getting into locked car trunks

#2

Re: OT - getting into locked car trunks

Andy Lincoln,In Dearborn MI

>Carol,

Is there any chance of a power trunk release ?Yellow button in the glove box? Other than that you've already hit on all my ideas.

Andy

Re: OT - getting into locked car trunks

#3

Re: OT - getting into locked car trunks

Ken Oakley-Sunny St. Cloud, Fla.

>Too bad she can't drive it to New York City. There she could pull onto the shoulder of any of the expressways, walk out of sight and return in 1/2 hour. Guaranteed every door,hood, and trunk will be wide open. She may need 4 new wheels, seats, radio, and possibly a motor and transmission though. Probably the doors, hood and trunk lid will be gone also.

Re: OT - getting into locked car trunks

#4

Re: OT- Printer recommendations

Binen

>First, do not assume a locksmith is out of your budget. Make a few calls and agree to meet them at their place. My guess is you can get it opened for $25 maybe less. If not you can pop the lock out with a slide hammer. This tool is a tool, with a heavy weight that slides on a rod against a stop and screw on the other. Simply screw the end into the keyway and a couple good jolts and the locking mechanism is removed. Then take a screwdriver and unlock the truck.

Binen

Re: OT - getting into locked car trunks

#5

Re: OT - getting into locked car trunks

Ron in Drums PA

>Option One:

Take a screwdriver and place it into the keyhole.

Rap the screwdriver a few times with a hammer while turning the screw driver to unlock the trunk.

Option Two:

Screw a slide hammer into the keyhole. Pull the weight back.

I saw these methods on TV once.

Never tried them.

Really.

Honest.

Re: OT - getting into locked car trunks

#6

Call a Chevy Dealership......

Scott in Eastern Iowa

>......and ask for their suggestion.

Locksmiths a great option too.

Re: OT - getting into locked car trunks

#7

Re: OT - getting into locked car trunks

Tom Stockton

>Carol,

This may sound stupid but try every key she has on the key ring or that she has lying around. Some cars have valet keys that will only open and start the car but not let you open the glove box and maybe the trunk.

Tom

Re: OT - getting into locked car trunks

#8

Re: OT - getting into locked car trunks

Curly Smith

>Assuming you are trying the right key (and, as Tom posts, that may be a bad assumption)...

try pushing down on the trunk lid as you turn the key

if it's not the right key, and you can't find one that works, then the Chevy dealer can make a trunk key from the VIN

Re: OT - getting into locked car trunks

#9

Depending On The Year Of The Car

Howard In Toronto

>You can call the maufacturer for the key code.

Once you have the key code you'll need to go to a dealership for that make.

Give the parts counterperson the key code and they'll cut the key using the key code.

To get the key code from the manufacturer, you'll need to supply the VIN (the Vehicle Identification Number which is that car's "serial number").

If your friend isn't the first owner it may get complicated.

Just have her ask how else they would need to identify that she's actually the current owner and have her round up that info.

Heckuva lot more practical thandrilling out a cylinder and living with those results until you can round up the rubles for a replacement.

Howard

Re: OT - getting into locked car trunks

#10

Smile at some jock, ........

Basil

>get him to lay on his back and slide under the car. There may be a plate (some GM cars have them) that is held in place by a goo (tar) that can be pushed out to allow access to the trunk interior. Insert arm and feel the trunk latch/lock mechanism, there should be a lever/thingy on the side somewhere that will unlock the trunk.

Look for a similar car/make/model/year that you can get into the trunk and inspect the latch/lock mechanism for the lever/thingy or slot where you insert a small screwdriver to unlock. Also raise the carpet while you're in there to locate the plate, if any, that will allow access from the under side.

Had to do this a couple of times for folks in the mountains in some primitive areas. They had locked all their keys in the trunk (both were Olds. Cutlass). If the trunk is stuffed full of junk already, it may not be easy.

Re: OT - getting into locked car trunks

#11

Lee Gordon

Re: OT - getting into locked car trunks

Lee Gordon

>Two thoughts. First, a locksmith is likely to cost far less than replacing the lock once you drill it out. Also, without a functioning lock, the trunk on your friend will not only not be able to be locked, it won't even be able to be closed without tying it down with rope or wire.

Second, if you do drill out the lock and don't replace it immediately, your friend can expect to be pulled over by the police fairly regularly for suspicion of driving a stolen car.

Re: OT - getting into locked car trunks

#12

Re: OT - getting into locked car trunks

Ernie Miller

>It's only $25 to have them open a lock at you place and $10 if you take it to them here in Topeka Ks neighbor had this problem last week.

Re: OT - getting into locked car trunks

#13

Call the 'Trunk Monkey' *LINK*

Tom Dunlap in Atlanta

>If you can't get in from the outside maybe these guys can come from the inside.


Trunk Monkey

Re: OT - getting into locked car trunks

#14

I was Wondering Who Would Post This!!!

Jim Shaver - Oakville, Ontario

>

Re: OT - getting into locked car trunks

#15

New ones too

Mark Goodall - ATL - tooljunkie

>I didn't realize there were a couple of new ones. They are hilarous, aren't they?

I was suprized/creeped out when my new car ( a couple of years ago) had a glow in the dark emergency handle INSIDE the trunk. Good idea, I guess. Kinda creepy though.

Happy Woodworking!

Re: OT - getting into locked car trunks

#16

You have to prove you own the car if you

Art Silva

>go to a Locksmith or dealership. A Chevy dealer is your best bet. Prove you own the car with registration, and driver's licience, and they can make a new key. If you walk in with just a VIN (vehicle identification number)no dealership will cut a key. I spent eleven years in the car business, and one of the greatest lessons learned was the story of a dealership whose employees in the parts department were lax in following the rules, and made keys for cars on their own lots. Think about it!