Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Laquer spraying

Posts

Laquer spraying

#1

Laquer spraying

Ron Sixby

>The piece of furniture is completley striped and sanded, this is a 2 tier table. (no old finish what so ever) Stained the piece about one week ago and today sprayed the finish. The top was off sprayed the top seperate from the bottom, and had a thicker coat on the top. Used Sherwin Williams Low VOC Cab. Lacquer Satin, the outside temp. was about 82deg. About 1 hour later the finish lifted, 'Oh Boy' what did I do wrong?

Re: Laquer spraying

#2

Re: Laquer spraying

Clint Searl, at the base of Haycock Mtn

>My guess is that the reduced solvent in the low VOC product inhibits the "bite" into the stain finish, especially if the stain is oil based. That, plus as the lacquer dries, it shrinks and pulls away from the surface. A heavy coat magnifies the problem. When I spray lacquer (coincidentally, Sherwin Williams) over a well cured oil stain, I start with a couple thinned light coats to seal back the stain, letting them flash off completely before the final coats. I never shoot without some reduction; it seems to work better for me that way.

Clint

Re: Laquer spraying

#3

Re: Laquer spraying

del schisler

>when i spray lacquer It is not a good idea to give a real heavy coat Build up is the way to go I use only a cabnet grade M.L. CAMPBELL low gloss is what i like I been using this for yrs and havent had any problums Also the sealer also by the same co. It is easer to put it on than take it off So lite coat's do work

Re: Laquer spraying

#4

Maybe too thick

Derek

>I sprayed a table and had to redo it a while later. I sprayed it too think (thinking it would be more durable for the family...). My mistake. The lacquer has a MAXIMUM application thickness (actually was on the can...), which I exceeded. That caused the problem.

I re-applied it at a reasonable thickness and it has been fine for well over a year now.

Re: Laquer spraying

#5

Thick coats....

Jason Roehl in Mulberry, IN

>Even though that S-W product is low VOC, the solvents involved are quite volatile. What happens when you put on a thick coat is that the top will film over, sealing in the liquid finish below it. At that point, just about anything can happen, all bad. Lacquer is best for it's quick dry times, which allow you to put on many thin coats in a short period of time, and for the fact that each coat will "burn-in" to the one below due to the solvents. Heavy coats do you no good whatsoever. At this point, you could try spraying on a little solvent which may let the finish settle back down. You may even have to do this several times. If not, you'll just have to sand it off and start over.

Jason