Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Kitchen stool

Posts

Kitchen stool

#1

Kitchen stool

Rob Stokes in North Vancouver

>Bought an old stool form a garage sale in Orting WA several years ago with the intent of copying it. I finally got around to it and made the prototype (which will be a wedding gift). I'm going to change a few things for the next one(s) - the round over radius on the seat, the "pork chop" shape of the ladder sides etc, but overall, I think this is a good start.


The wood is silver maple that we "home milled". The tree was one of many that was planted near 1880 or 1885 and lined the driveway of an original homestead in Surrey BC. It fell in a windstorm and we "rescued" the wood (milled with an Alaskan mill and kiln dried it).

The rungs (made on a router table) have tapered ends and the mortises are also tapered (and blind). The rung that supports the ladder pivots freely in the mortices allowing the steps to fold/unfold.

For a finish I started with Don Kondra's recipe of varnish/tung oil/thinner and japan drier and modified it a bit based on local ingredients. It's a wipe-on finish that seemed to work well. But next time I'm going to un-modify it and try it "stock" as I've since located "real" tung oil and not the diluted product I substituted.

Fun project - I built a bunch of fixtures to assure all the holes were drilled at the correct angles and also build an assembly fixture to hold everything in the right place while gluing/assembling. This should knock the build time down considerably next time.

Rob

Re: Kitchen stool

#2

Re: Kitchen stool Drool

George@Colonel's Workshop-Havertown PA

>Good Afternoon Rob,

We are going to fabricate one ourselves. Very nice job. Practical in the kitchen, and indispensible in the jon for giving our little grandsons sufficient height to perform! :<)

George

Re: Kitchen stool

#3

Re: Kitchen stool

Jim Shaver - Oakville, Ontario

>Hi Rob,

That is a design that is very efficient and would be useful in many kitchens I can think of. I like that you found some wood of local significance to also add that extra special story to your fine work. I know it will be a gift that will be appreciated for a very long time, well done.

I too have a blend I use for my finishing that is similar to Don�s. Up until now I was using boiled linseed oil in my blend and Don uses tung oil as you mentioned. I asked him what the difference was and his comment was something like the effect of light beer vs. real beer.

Again well done,

Take care,

Jim