Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

"Coatings" or whatever on bits and blades...

Posts

"Coatings" or whatever on bits and blades...

#1

JL

"Coatings" or whatever on bits and blades...

JL

>So, other than scraping and peeling off the coatings which can be somewhat frustrating for a complex bit - what does everyone else do? It's not so bad with a straight bit, but rail & stile bits or an 80 tooth saw blade? Does someone have a different suggestion? Should I just run some scrap lumber through the saw or router?

Re: "Coatings" or whatever on bits and blades...

#2

Re: use pocketknife to score and peel.

Al Crandall (N.E. of Indy)

>

Re: "Coatings" or whatever on bits and blades...

#3

Re: "Coatings" or whatever on bits and blades...

Rob Stokes in North Vancouver

>Sometimes I peel it off, sometimes I taker the majority of it off and run a piece of scrap with it to clean the rest of it off. Regardless, I always run a piece of scrap after the coating's been removed to get rid of the residual oils etc.

Rob