Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

I Know I've Seen One, But

Posts

I Know I've Seen One, But

#1

I Know I've Seen One, But

George (Oxford, NC)

>I can't find the style lock I'm looking for. Picture the handle/lock on a P/U cap. You twist the handle and there are two bars that extend into the sides and lock the door shut. I have seen this on a smaller scale with a key that you turn, as in a regular lock, for furniture. Basically, you turn the key and the bars extend into mortices on the sides of the opening, pull the key out and the door/panel/drawer is locked. Turn the key and the bars slide back towards center thus freeing the door/panel/drawer to open. I can find the 'rotating' bars where the bars rotate and have a hook at each end that goes around a little peg. This won't work for me. The application I have in mind has to have the sliding/extending bars that go into a mortice. Any good memories out there of where this might be found?

George

Re: I Know I've Seen One, But

#2

Re: I Know I've Seen One, But

Rob Hix - King George, VA

>George,

I am looking for the same thing. I have a post below ("Help findin a lock..."). A suggestion was made that will work for me, but still not quite what I was thinking about.

Hope this helps,

Rob Hix

Re: I Know I've Seen One, But

#3

Lee Gordon

Re: I Know I've Seen One, But *LINK*

Lee Gordon

>It sounds like the kind of lock used to secure filing cabinet drawers. The link below shows one type but that same company has other versions on its website. It can be called an extending bar lock or, alternately, a rotating bar lock.


Extending Bar Lock

Re: I Know I've Seen One, But

#4

Re: I Know I've Seen One, But

George (Oxford, NC)

>I have found things close but no cigar. I think I might look into getting a 'cam lock' that has a double ended bar on the back instead of a single end (or make a double bar to fit) and then buy some brass rod, flatten one end, drill a hole in it and the ends of the cams and rivet them together with enough play to allow them to turn. I would then sandwich this between two boards, one routed out with the appropriate sized groove, and have holes in the ends to support the bar. This, I think, would give me a round key face as seen from the out side and allow the bars to go in and out of a round mortice in the side panels.

George

Re: I Know I've Seen One, But

#5

Ellis Walentine

What you're looking for...

Ellis Walentine

>...is a double-door latch. I have used them on jobs, but I can't remember where I got them, possibly CH Briggs hardware, an industrial supplier here in PA. They are designed for situations where you have two hinged doors meeting each other at a rabbet/shiplap joint. I have never gotten one with a lock cylinder in it, but if they make them for pickup caps, they must exist. You might want to pilfer one off an old junker truck cap. The ones I used were solid brass. Hmm, I wonder if it was Baldwin?

Not much help. Let us know if you find one.

Ellis Walentine

Re: I Know I've Seen One, But

#6

Lee Gordon

Re: I Know I've Seen One, But

Lee Gordon

>The more I think about it, the more I think what you're describing is precisely the mechanism used to lock a garage door. Would one of those be too big for your application (even if you cut down the metal bars)?

Re: I Know I've Seen One, But

#7

Cremones?

Curly Smith

>I was thinking about these yesterday:

Cremone Bolt Set

Cremones