Purchased drawings - long explanation and question
Hub in Ontario
>Last fall, in an issue of Fine Woodworking, there was an article on that caught my eye on a country hutch built by Marty Milkovits. This article was especially timely as I was/am considering building just such a piece and the drawings for this piece could be purchased through FWW.
So I ordered them and waited anxiously. Now I must say that I live in Canada and the mail service between here and the US is notoriously slow and it was just prior to Christmas but ���... When they did arrive, I gave them a cursory glance and immediately noted a number of dimensional errors on one view. I sent an e-mail to the folks at FWW in late January and after a reminder e-mail, in late March they did send me a note saying that they had also found a couple of errors and would send corrected drawings. In the interim, I noticed some corrections in the editorial pages of a subsequent issue of FWW and on March 15 I received an e-mail from FWW telling me of an additional 20 errors and the corrections. I was also told that if in doubt, I should use the scale and measure the parts.
Low and behold about two weeks ago I received updated drawings and again I gave them a cursory glance and what do I find, yet more errors. I wrote to them about the errors and I was once again told that �when in doubt, follow the scale, not the text�. I was also told, and I paraphrase, that the drawings are a guideline and the error some folk make is following the drawings too closely ?????
After this lengthy explanation, I am left wondering if it is me. I was from an industry where the drawings were the rule and you followed the drawing. I admit, I am not as experienced or as talented as you folk hence my desire to buy the drawings but am I wondering I am wrong in that I should expect complete and correct drawings.
I will go on record as saying the folk at FWW have been very nice but I cannot buy their explanation and as a result, I don�t feel I can buy any more of their drawings. I am really hestitating committing the cherry to this project.
I also want to say that Marty Milkovits has been both very helpful and understanding of any questions I might have.
Am I just too inexperienced or expecting too much? � comments?
Thanks in advance
Mike



