Turning on a drill press
Tom Dunlap in Atlanta
>I need to make a few small turnings but I don't own a lathe. There have been plans and ideas for turning on a drill press but I can't zero in on any setups.
Does anyone have a lead for me?
Thanks,
Tom
Knowledge You Can Build On — Est. 1998
Turning on a drill press
Tom Dunlap in Atlanta
>I need to make a few small turnings but I don't own a lathe. There have been plans and ideas for turning on a drill press but I can't zero in on any setups.
Does anyone have a lead for me?
Thanks,
Tom
Re: Turning on a drill press
Curly Smith
>This might give you some ideas:
In addition, using the drill press as a lathe used to be a periodic discussion topic on rec:woodworking. This link is a Google Groups search on "drill press lathe" and it should give you enough info to get started:
FYI - the search result titled "Drill press lathe??" from 4/24/99 says Shopnotes issue 108 has the plan you're looking for...
Thanks Curly...
Tom Dunlap in Atlanta
>...I googled "drill press lathe' before I posted. After scrolling through over 200 listings of tool sales and nothing about what I'm talking about I decided to tap the WC Borg's knowledge.
Now I have a good focus.
Tom
Another solution *LINK*
Tom Dunlap in Atlanta
>Using Curly's direction I found another idea that could work for me...
Tom
Lathe Fox
One more jig source
Curly Smith
>supposedly there's also a jig on page 78 of this book:
200 Original Shop Aids & Jigs for Woodworkers
(or page 78 of the non-revised version)