Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Thumbnail molding update

Posts

Thumbnail molding update

#1

Thumbnail molding update

Barry Irby

>Thanks to everyone who responded on my questions about a thumb or thumbnail molding on the edge of a table top.

(Carol, I made an offset router base and it was a big help. Thanks. Need to do it over out of better materials, but you were right. Also, thanks for reminding me to slow the router down.)

I wanted to note that I went to Woodcraft and bought a bit. They had a CMT bit and it was about $109. Whoa! More than I wanted to pay for a bit I may or may not use again. I asked if they had something else and they went "um, er, we have this Woodcraft brand one". It was $47. I went with that one. I was having a little trouble paying more than twice as much for a bit that appeared to be extremely similar. All the way home I was wondering if there was some subtle difference I could not see. I ran the bit on some practice stock and then around the table. If it could have done a better job, I don't know how. Kudos to the not so cheap Woodcraft bit. Clearly the right decision.