Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Crown Mldg. in a bathroom question

Posts

Crown Mldg. in a bathroom question

#1

Crown Mldg. in a bathroom question

Nat Robison

>I'm finishing up a basement bathroom that will have a low ceiling in it, roughly 7'6". The ceiling is all one plane with no divider walls anywhere in the room.

I'd like to consider putting in crown and I guess I could stop it short of the shower and put returns on it but I don't think I'd like the look. I'd rather have the crown in the whole room, shower included.

Any foreseeable problems with this? If the wood crown is primed on every surface (I'm consider the water/shellac-based primer from Zinsser), caulked in, and then everything primed again, would it be enough?

Re: Crown Mldg. in a bathroom question

#2

Re: Crown Mldg. in a bathroom question

Jim Dillon

>Nat,

While I have no experience with crown molding per se, I installed our shower/tub about seven years ago and trimmed all the edges with plain old pine molding. I first primed with Zinsser (two coats I think), let it dry overnight, then followed up with two coats of gloss latex. Have had absolutely no problem and five of those years were without air conditioning. So I think you will be OK. Good luck.

Jim

Re: Crown Mldg. in a bathroom question

#3

Re: Crown Mldg. in a bathroom question

Jim Moore

>I do not foresee any problems with the crown as long as it has a good coat of protectiion on it, such as poly. I've got wood in my bathroom and have no problems with it. It does not ever receive direct splashing of water and neither should your molding.

Re: Crown Mldg. in a bathroom question

#4

Re: Crown Mldg. in a bathroom question

mdclor

>I've never had wood molding in a shower, but would be concerned about mold/mildew, especially in a basement shower. You might benefit from discussing with LOYL before installation.

Good luck,

Merle

Re: Crown Mldg. in a bathroom question

#5

Jim in Burlington Ont.

Polystyrene

Jim in Burlington On

>I'd put up Polystyrene crown moulding in a shower or bathroom. I have that up in my bathroom for 4 years now no problems. I also have it in the kitchen for quite a few years and no problems with the heat and hot water either.

Re: Crown Mldg. in a bathroom question

#6

Another thought...

Jim Dillon

>... that you might consider is to use a mildewcide agent in your paint. They are rather expensive (roughly $4 for treatment of a gallon of paint) but are effective in reducing mold that might grow on your molding (or wall paint). The agents are sold at your local paint stores or the borg.

Jim