Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Omnijig problem

Posts

Omnijig problem

#1

Omnijig problem

Pat Evans

>I have a hard time getting the front clamp on my Omnijig adjusted to get sufficient clamping pressure. Today, I wound up reaching behind the jig and tightening the nuts with a wrench after using the clamp handle. A real PITA, but better than having the stock slip while routing dovetails. Do any other Omnijig owners have problems with the front clamp?

Re: Omnijig problem

#2

have you tried ...

Ian (in Sydney, Australia)

>tightening the nuts at the back by hand BEFORE doing up the front knob?

I don't have an Omnijig, but the tightening process you describe (front knob then use a wrench to tighten the rear nuts) is the opposite to what works for me with the "quick release" clamps on the kid's scooters and bikes.

Re: Omnijig problem

#3

Re: have you tried ...

Pat Evans

>Yes, I normally tighten the nuts by hand with the stock in place and the clamp handle open. However, the bolts to the clamp bar tend to drop down in front. If you tighten the handle without lifting up on the bar, it isn't really tight. Any upward movement will loosen the clamp. Also, trying to hold the stock in place, lift the clamp bar, and tighten the handle simultaneously is difficult at best.

I have also found that I need to leave the clamp bar slightly loose rather than snugging up the nuts. The cam mechanism won't lock well unless the handle rotates at least 90 degrees. The problem is that even at 90 degrees, it doesn't really lock but just jams the bar in place. Vibration will still tend to loosen the clamp.

Just wondering what other Omnijig owners experience.

Re: Omnijig problem

#4

Re: Omnijig problem

Curly Smith

>I don't have an omnijig but...

it sounds your wrench is telling you the nut/clamp is tight before it really is tight.

Possible problems:

The threads on the nuts/bolt are not in good condition. Remove them and chase with the appropriate tap/die.

The bolt is bent. Remove and verify that it is straight (if bent it's binding on the jig).

The end opposite of the clamp is not straight/square (it's binding making it feel "tight") Verify that all is in good repair and lubricate as necessary. (You could also try squeezing the opposite end with a small clamp to see if things improve.)

The bolt holes are not aligned. Could be a manufacturing defect, could be an assembly problem. Remove nuts and verify that bolt moves freely.

I hesitate to mention this but are you sure you're rotating the cam clamp in the right direction? I, of course, would never try to use one backwards but I have heard stories...

Have you tried swapping parts from the back clamp? The front clamp may have a manufacturing defect.

You could also cut a small plastic spacer to slip under the clamp after you get it mostly tight. The extra thickness should enable you to get it tight.

Re: Omnijig problem

#5

Re: Omnijig problem

R. Lance in G. R., Michigan

>I have an Omnijig and if I apply pressure to the front of the locking bolts by pushing against them with one hand, then I can reach into the back with the other hand and adjust the locking nut with no problem.