Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Flattening a warped cabinet door

Posts

Flattening a warped cabinet door

#1

Flattening a warped cabinet door

Brian in SLO

>I just finished making 17 cabinet doors in our new kitchen and they all came out great with the exception of one! It figures doesn't it?

The problem is that it came out with a warp. It is made from solid maple rails and stiles with mitered corners and a flat 1/4" ply panel. I used Titebond II for glue.

I thought about steaming it but I don't have anything large enough to steam it with. Could I possibly put it in the oven with a tray of water and steam it that way? Or any other ideas to flatten it?

Thanks!

Re: Flattening a warped cabinet door

#2

Sometimes

Lee Schierer, McKean, PA

>Sometimes you can wet the panel on the concave side and forcibly bend it past flat the other way while it is wet and it will stay flat when it dries out. This works maybe 10% of the time. It is also possible that when you glued up the panel that you had it twisted, in which case you can take it apart and make new railes and or stiles and use the same panel over again.

Good luck,

lee

Re: Flattening a warped cabinet door

#3

Re: Flattening a warped cabinet door

Jim Dillon

>Brian,

I wish I knew of a good solution for this type of problem (I could use it on a vanity I built), but I don't. There was a thread on this topic a year or so ago and - if I remember right - there isn't a lot one can do, except do it over 8-(. It can be caused by overzealous clamping during glue-up, or by the door panel not being absolutely flat against the clamps at all four corners during glue-up and the clamps not being level to begin with. If you used European hinges, maybe you can "balance" the portion sticking out with the opposite side. Or maybe use double the thickness of "bumpers" on the backside of the door to minimize the gap between door and faceframe. Both are not very satisfactory solutions. Good luck.

Jim

Re: Flattening a warped cabinet door

#4

If you have to take it apart to reglue

Don Henthorn

>remember that with Titebond glue heat and pressure are your friends. The thermoplastic glue will surrender with careful heating and pressure.

Re: Flattening a warped cabinet door

#5

Re: Sometimes

Ryan Dicker in Renfrew, Ontario

>I have used the method of wetting the concave side of panels to warp back a section of a dining room table top. The piece was 1" oak, 30" x 44"....I washed down the concave side with a wet rag and then left the concave side down on a table for the weekend. Whether or not it was just the convex side just drying out that did it, the method still worked well. I could stick a pencil under the panel when it was placed concave down on a perfectly flat surface.

Now in your case, is it just the plyboard that is warped or are the rails causing the plyboard panel to warp? You may just be able to clamp it concave down on a table top and flatten it back out. I don't know if the wetting technique will work on the plyboard though....

Hope this helps,

Ryan