Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Cabinet Doors - opinions sought

Posts

Cabinet Doors - opinions sought

#1

JL

Cabinet Doors - opinions sought

JL

>Flush with the face frame or inset? I can get hinges with a 3/8" offset or I can just leave the doors flush with the face frame. They are similar in price, so that is not a consideration. It would just take a couple of passes on the router table to inset the doors after I get them built.

Re: Cabinet Doors - opinions sought

#2

Re: Cabinet Doors - opinions sought

Clint Searl, at the base of Haycock Mtn

>I find insets a greater challenge to install, but think they are a classier look than overlays. If the doors are solid lumber, seasonal expansion is a factor favoring overlays.

Clint

Re: Cabinet Doors - opinions sought

#3

JL

Re: Rail and stile w/ plywood inserts..

JL

>these are shop cabinets. I am trying my hand at rail and stile - and I am learning a lot (always have a backer board or you'll get lots of splinters!!).

Re: Cabinet Doors - opinions sought

#4

Re: Cabinet Doors - opinions sought

George@Colonel's Workshop-Havertown PA

>Good Afternoon JL,

For shop cabinets, I'd go with overlay cabinet doors which are quickly and easily installed. They also provide a degree of shadow line and depth. The inset doors are more difficult to fit, as another post mentioned. They both look great when done well.

George

Re: Cabinet Doors - opinions sought

#5

Re: Cabinet Doors - opinions sought

jmohnike

>Why not try a frame and panel door? Make the Panel out of pegboard and then they will have an additional use, to hange small items, not as nice a looking door, but given the added usage may be worth the effort. (just a thought)

Just use 1 additional hinge.

Joe

Re: Cabinet Doors - opinions sought

#6

JL

Re: I'll go with overlay.. Thanks

JL

>