Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Changing Planer knives....Mistake

Posts

Changing Planer knives....Mistake

#1

Changing Planer knives....Mistake

Barry Irby

>I have one of the lunch box planers that has knives you can sharpen (Dewalt 733). I have two sets of knives and I sharpen them myself. I got a nick on one set, so rather than grind them down far enough to get rid of the nicks, I decided to swap one of the knives with the other set. I sharpen them both at the same time and as far as I can tell they are Identical, but I was a little worried about "dynamically balancing" the head. I held the knives side by side and I measured them. They appeared to be Identical. I installed them last night. I was tired and feeling run down, wondering if I were coming down with a cold.

Today, I ran a prized piece of quarter sawn heart pine through the planer and discovered that one of the knives was not set right. When I turned the machine on, it vibrated slightly more than usual, but I attributed that to swapping the knives in spite of all my measuring. A number of weird things happened. The feed rollers would not pull the piece through, the snipe was terrible, there was snipe all along the piece and the surface was quite scalloped. It took a minute for the light to go on in my head and I finally looked at the setup on the knives. Apparently I did not properly set one of the magnetic gages and one blade was about a sixteenth ahead of the other.

I had the little depth gage set on the planer and it was not supposed to go below 3/4", but with the knife out of whack, it did.

I reset the knives being more careful. No more vibration. It also turns out the "leading" knife was the one with the nick and it left its little bead. By the time I cleaned up the board I had just under 5/8". Bummer, it was supposed to be the top of my huntboard.

So, there are lessons here. Don�t do this stuff when you are tired and not thinking well. Use good light, the problem was obvious in daylight, but not so obvious last night. Check and recheck. Run a test piece first, a scrap that will tell the tale without ruining something you prize. Pay attention to your instincts. I should have wondered more about the vibration.

Yet another mistake I have made to save you the trouble.

Re: Changing Planer knives....Mistake

#2

Re: Changing Planer knives....Mistake

MountainMan

>Hey Barry

It also helped me a bunch to have the planner setting jig called "planner pal" It is simple magnetic system which is easy to use and will set each blade perfectly the first time!! I always put a wide peice of pine or aspen through the planner - check with my calipers - both ends of the blades cuts --- works every time!!

Regards

The MountainMan

Re: Changing Planer knives....Mistake

#3

Thanks for the Reply......

Barry Irby

>This was an amazing experience. The planer comes with magnetic setting guides, but this is a lesson in the fact that you still have to be alert and pay attention to what you are doing.

The effect was very interesting. Since the stray knife was cutting away way too much wood, the outfeed roller did not press the wood down to the table. This allowed the wood to rise erratically and the knife cut an even deeper snipe into the board. A series of scalloped troughs across the board. It also allowed the board to tip down on the way out and generate horrible snipe on the trailing end.

Re: Changing Planer knives....Mistake

#4

Glad I'm not the only one

Terry in Edmonton

>