Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Cabinet opinion?

Posts

Cabinet opinion?

#1

JL

Cabinet opinion?

JL

>Okay, I'm starting to cut the plywood for my cabinets. I am figuring that the "grain" on the sides should be vertical and that the "grain" on the tops, bottoms and shelves should go the long way. What about the backs? For the 2' units, I'm having the "grain" be vertical.

What about for backs of the wider units (33" and 36")? I could go either way. I'm thinking vertical would be a better choice, but it isn't as if anyone will ever look at them. Opinions?

Re: Cabinet opinion?

#2

Re: Cabinet opinion?

Sawdust Maker

>Use it either way. Nobody's gonna look at it!

Plywood is stable will not expand or shrink like solid panels. Doesn't matter which side is up.

Good luck with your project

Re: Cabinet opinion?

#3

Re: Cabinet opinion?

Bill Houghton, Sebastopol, CA

>Plywood is stiffer and stronger in its length than across its width, at least at certain widths. For instance, I've put down 1/2" plywood in my attic as storage flooring. On the advice of the lumberyard, I put it down with the long grain of the outer plys running across the joists, and it's noticeably stronger that way. I've split a couple of sections when I accidentally stepped on them while they were placed width-wise across the joists.

So you're correct to run the length of the plywood along the length of the shelves.

However, for a cabinet back, it may not be significant; seems to me the stresses transmit across the whole sheet of the back, in shear as it were, so grain shouldn't matter much.

Re: Cabinet opinion?

#4

Makes no difference either way, anyway

Clint Searl, at the base of Haycock Mtn

>

Re: Cabinet opinion?

#5

Re: Cabinet opinion?

Carol - Strawberry, AZ

>Technically, you are right, but there is another thing to consider.

Cabinets are something that usually stay with the house when you sell and leave. When potential buyers see something unusual, like plywood going the 'wrong' direction to their eye, they begin to suspect everything else they don't understand. And forget about explaining. You are the seller. Everything you say is suspect.

So to save a couple of bucks now, may cost you (or your heirs) tons more later in.

Just my two cents.

Re: Cabinet opinion?

#6

Re: Makes no difference either way, anyway

Jim Toews - Walla Walla, WA

>I agree that it really makes no difference, but I'm just anal enough that I always try to have all vertical surfaces with the grain running top to bottom. Weird, I know, but that's me. If it were a shop cabinet, though, I'd go with whatever was most economical.

Cheers!

Jim

Re: Cabinet opinion?

#7

Paint them

Dustmaker Mike

>Yup paint the insides a Gloss White and it will not matter, it is easier to clean and it looks neat and clean. If you are staining them then up and down cause of what Carol said. I am looking at houses now and the small things stand out fast to people that look at different things.

In others words I look at all the stuff most folks never notice in a house until it goes bad.

Re: Cabinet opinion?

#8

Re: Cabinet opinion?

Larry Clinton At Frankfort (Central)., Indiana

>When I built my upper shop cabinets (bout' 75 running foot), I did a cut sheet layout. I designed the cabinets to take advantage of the sheet size and reduced my scrap to almost nothing. I sure wouldn't scrap a lot of plywood just to orientate the grain of the backs a particular direction.