Re: New House New Shop Almost
Rich Schneider
>You can repaint the aluminum siding...there are a few issues to be aware of and consider before taking this approach....one, you need to powerwash it to clean and remove the chalkiness of the old finish, when you do this you need to be careful to wash in the downward direction to prevent blowing water up under the laps of the siding..two, then you need to let it dry really well and not just overnight, a few days at least...three when you paint it use some Emulsabond mixed into the paint to improve the bond with the existing paint (you need to spray it on not roll or brush it or it will look like crap)..a pro paint supply shop will have it and can tell you the right ways to mix it...if you follow the label it will be a little too much Emulsabond..but again get local, reliable, advice on it...you need to be very consistent in the mix since Emulsabond is white and will lighten pigmented colors..four, realize that aluminum will expand and contract, so you use a different color from the oringial you will likely see a line of the original color at the joint when the aluminum contracts in cold cold weather....you can also do the same thing with vinyl as well...the risks are 1) the joint color I talked about above, 2) if you don't prep correctly or use a bonding agent like Emulsabond you run the risk of sheet peeling..3)paint life is approx 15 years at best, so you'll be doing it again in the future...I've done this with steel buildings, aluminum and vinyl siding with good success, but realize that its not like new siding..dents, dings, holes, etc will still be there and will show even worse after painting...you may be farther ahead to recylce the old and go with a top quality vinyl or a steel instead.....