Re: O.T.: Computer monitor display problem
PaulA
>Scott
"Actually, Paul, I'll have to disagree with you on refresh. To start off with, most CRT monitors these days can refresh at multiple frequencies ("multi-sync") and can display many different resolutions. LCDs, in constrast, have a fixed refresh rate (60Hz) and a fixed resolution. That's a big difference right off the bat!"
The operation is a bit different than you stated. A given LC monitor has a fixed number of pixels, but those pixels can be addressed in numerous ways and refreshed at different refresh rates, including above and below 60 HZ. So, for example, a 1280 x1024 monitor can be run at 1024 x 768, or 800 x 600 or any other "standard" that the monitor driver is programmed for. When it does this the pixels are remapped and depending on what you are doing you may not like what you see, but it is done all the time.
Data transmitted to the display, whether digital or analog HAS to be in sync with the refresh signals. One of the real benefits of DVI is that one of the signals transmitted to the display is the pixel clock signal so the pixels will be jitter free no matter what the data rate. VGA does not have a pixel clock signal and the clock has to be recreated in the display from the sync signals leading to time jitter in some cases and especially at higher data rates and with cost reduced electronics.
VGA signals can drive both CRTs and LCDs. That works because they are both refreshed displays, they are both multi-sync capable, and they both have to have the data locked to the horizontal and vertical sync signals.
Wow! this does not sound like a woodworkers forum. Did I mention that both type displays can have wooden bezels with dovetailed corners.
Paul