A question(s) about quarter sawn?
Bill Tindal, E.TN
>There is the NHLA definition of QS which allows the growth rings to deviate some number of degrees from "true" quarter sawn (30 if I recall correctly). So in fact "quartered" commercially graded lumber contains pieces with grain that would be considered "rift" if it was veneer. I suppose this results from the practical matter that I don't know any way to hold a log on a modern carriage to cut most or even much of it true quartered.
When I have had logs "quarter sawn" some slabs are taken off opposing sides of the log, the resulting "cant" is sawed through the heart and these more or less half logs are then laid down on the carriage and sliced to yield rift grain on the edges and more or less quartered toward the middle. This technique is the best that can be done on a modern carriage (as far as I know) while providing stable support for the logs(cants) and a place to secure it with the dogs. Alternatively, many mills now saw cants and send them through a gang saw. This process will yield a board or two from each cant that is true quartered, but usually of low grade.
Given this background that I have never seen a modern mill that could produce much "true" quartered lumber from a log my questions are many.
1.Is the lumber you speak of "true" quartered or quartered by NHLA definition?
2. If "true" as defined by growth rings 90 degrees to the board face, how is it produced in any quantity? The answer could be "selected from rift". But if it is sawed that way what is the sawing technique?
The motivation for the question is I have bought a 450 bdft poplar log that, for a special application, I want to get as much true quartered lumber from it as possible.