Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Need a 4" adapter

Posts

Need a 4" adapter

#1

Need a 4" adapter

jeff

>Hi all

I need to find a supplier for a 4" to shop vac (2 1/2") adapter.

Most of them are the type that fits the 4" pipe (male fitting).

I need the type to go onto the 4" outlet of a tool (female fitting).

Everyone sells the first type (male), but not the second type (female).

I bought one 3 or 4 years back (so I know their made), but can't seem to find it now.

Anyone one know off hand who sells it?

Jeff

Re: Need a 4" adapter

#2

Re: Small section of 4" hose and two clamps!

Kris Lasure

>

Re: Need a 4" adapter

#3

Re: Need a 4" adapterWhat I did

Lee Schierer, McKean, PA

>I use my shop vac hose on my Dust collector to sweep the floor. I had a similar problem. What I did was to take two pieces of 3/4" wood, glue them together to make a block 1-1/2 thick and the same dimension on a side as the inside diameter of the 4" pvc pipe fitting. I used the circle cutting jig for my band saw to cut the OD to size. Then I used a hole saw to saw out a circle in the center of the disk, creating a donut. A little sanding with my spindle sander and I had a reducer. The vacuum holds the piece in place. If it slips a bit, run a thin layer of silicone sealant around the outside circmference and let it cure, it should be enough to hold the adapter in place.

Lee

Re: Need a 4" adapter

#4

Try Penn State Industries or Jet

Dave Bair, Eaton Rapids, MI

>