Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

aftermarket pc 7539 micro depth adjustment ?

Posts

aftermarket pc 7539 micro depth adjustment ?

#1

aftermarket pc 7539 micro depth adjustment ?

john jesseph

>Hi all, just dug out my old PC 7539, hoping to do some routing. I have owned it about 12 years and really never did much with it. I set it up tonight to do some rabbeting and see that the depth adjustment is very cheesy and imprecise. The add-on PC adjuster doesn't look all that much better via the net, maybe it isn't too bad.

Any other suggestions or solutions? Thanks! John J.

Re: aftermarket pc 7539 micro depth adjustment ?

#2

Re: aftermarket pc 7539 micro depth adjustment ?

Dave Morris

>John, since nobody has offered any good advice, I'll take a SWAG... I'm guessing you mean that "fine tuning" the depth of your rabbet is kinda hit and miss-- too much, or too little, but danged hard to get it right.

Try this: Get it as close as you can visually, take a test cut. Too deep? Set a piece of paper on the bottom of the rabbet so only the bit touches it, then re-adjust the depth so the rest of the router base in now on the flat surface of the piece being rabbeted. You've just adjusted your router about .002" to .004", depending on the grade of paper.

Too shallow? Put the paper under the router base, and then re-adjust the bit so it touches the bottom of previous rabbet that was too shallow. The bit will now cut a rabbet that is one thickness of paper deeper than it did before.

No, it's not high tech, but it works. I've also used paper to fine-tune the position of my router table fence for sliding dovetail cuts. Again, it's not pretty, but it works.

Dave--- who *still* can't remember if it's "rabbet" or "rabbit". Oh, well, you know what I mean...

Re: aftermarket pc 7539 micro depth adjustment ?

#3

thanks!

JohnJesseph

>

Re: aftermarket pc 7539 micro depth adjustment ?

#4

Some other options

Derek

>You can make or buy shims which are the depth you want. The brass ones are over-priced, but available.

Rabbit depth is not that critical, usually, so a wooden one would work just fine. It would not bee too hard to make 3/8" or 1/4" wooden shims.

My routers have pretty good depth adjustment so I'm fine without except at the router table.

There are also router depth gauges. They work OK except for plunge routers since it's hard to use them. You have to plunge the router and adjust the depth stop and hold the gauge at the same time and most of us do not have enough hands!

Now if someone figures out how to get me another hand that would REALLY be handy! :>)