Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Band Saw resawing problem

Posts

Band Saw resawing problem

#1

Band Saw resawing problem

Dale Stillman

>I am re sawing 3-1/2", 4-1/2" & 5-1/2" wide boards. Taking off approx 1/4" of ea. I have the Timber wolf 1/2" blade on now. Just took off the Wood Slicer 1/2". Problem is I am getting a bow in the center of the cut. Both blades are for re sawing. I just installed the Jet Carter like guides. Did not correct the problem. What am I doing wrong? The saw is a Jet 14". TIA for the help.

Re: Band Saw resawing problem

#2

Re: Band Saw resawing problem

Brian Gaynier

>Dale,

I just tried re-sawing for the fist time last moth and had great success. Just by chance I had picked up a copy of the February 2007 FWW, which had a great article by Lonnie Bird. I followed his directions for setting up my 14� Craftsman BS with a 3/16� blade with 4 tpi. I was slicing 5� Tiger Maple (veneer for drawer fronts) at nearly 1/16� with uniform thickness.

Hope this helps,

Brian Gaynier

Re: Band Saw resawing problem

#3

Re: Band Saw resawing problem

markfromsacramento

>It could be occurring for a number of reasons. The most likely culprit is that you are undertensioning the blade. Crank up the tension and try it again and note whether it improves. It could also be caused by feeding the wood too quickly so slow down a bit. It is also possible that a dull blade (not likely here) and wheel alignment problems could contribute but I'd start with the feed rate and tensioning.

Re: Band Saw resawing problem

#4

I agree

Lee Schierer, McKean, PA

>I've seen the same thing in my limited resawing expereince. A bow in the cut from top to bottom means too little tension and / or forcing the cut.

Lee

Re: Band Saw resawing problem

#5

Re: Band Saw resawing problem

Ken Krawford

>Dale,

I posted recently about resawing problems on my bandsaw. One of the best suggestions involved cutting a 1" deep kerf on the top & bottom of the cut. I also agree that too low tension may be a problem.

Re: Band Saw resawing problem

#6

Re: Band Saw resawing problem

Dale Stillman

>Tension &/or speed were the problem. Thanks so much for the help. Nice flat surface now.

Re: Band Saw resawing problem

#7

Re: Band Saw resawing problem

Barry Irby

>Glad you got it straight 8). My limited understanding is that it is called "Barreling". If there is too little tension on the blade it cuts a curved path and increases it own tension. Glad you got it working. I had it come right through the side on one piece. Good way to cut a finger tip.