36-444 Contractor Saw with stuck tilting mechanism
Pat Barber
>My faithful contractor saw got a bad case of stuck sometime
over the holidays. I don't use it much anymore since I got
a large 12/14 cabinet saw a couple years back.
It's assigned duty is now strickly a dado machine and
it does it quite well.
I was making some moding and had the saw in a 45 tilt
and left it that way for a month or so.
When I went to put it back to 90, it would barely move.
I finally got around to tearing it down this week and
with a wrench, I back off the large locknut on the right
of the picture. As soon as I backed off the nut, I could
easily turn the handwheel and bring the saw back to 90.
I consulted the manual, and that entire deal is for removing
"backlash". I'm not clear how the rod can possibly turn if
that locknut is tighten down. I also don't understand the
"eccentric" they refer to in the manual.
Anybody ever got into one of these ????



