Turning

Subject:
Re: This is the time
Response To:
Re: This is the time ()

Mequipment
Some basic parameters for a VFD controlled lathe starts with the main purpose. (Speed Control)
Speed Control from the POT switch, a jumper is usually required for this input on basic VFD's.
Ramp up in speed (parameter)
Ramp down in speed (parameter)
Braking control (parameter)
Frequency Options (parameter)
Torque Options (parameter)
Over Current (parameter)
Under Voltage (parameter)
Every manufacturer has a different list of parameters for their series of VFD, you need to review the list of parameter names to determine which ones apply to the task you are needing to program. Depending on the origin of the VFD, engineers from different countries use slightly different terms for the same thing. Parameter settings usually end up being a fine tuning of the VFD while you make small changes to the different parameters until you are happy with the operation and performance of the machine.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081