Turning

Subject:
Re: It's Running Again
Response To:
VFD for PM3520A ()

jake Niedling
Yesterday, I must of tried it 20 times and each time it faulted on over current at around 300 rpm or so. Well after setting unplugged all night, today I had to check it again and it ran normally with no over current fault. Must of tried it a dozen times today and each time it ran normally with no faults. I turned a simple christmas ornament tonight without problems. So not sure what to make of it. I think I will call Powermatic Tech support tomorrow and talk with them. I guess moving it around a little and giving the area under it a good clean up, did the trick. :)

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081