Turning

Subject:
Wooden Die/pulley??

Tom Norton
I am needing to turn some dies for bending 3/8" tubing. I am making a tubing bender.I am building a rack for a bicycle.
Since I don't turn very often I could use some tool advice.
The blank is 1" thick x 3" in diameter.
I need to create a groove 3/8" wide x 3/16" deep.
Which tool? Scraper?
Thanks!

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081