Turning

Subject:
Re: How will you remove the pulleys? Nova 3000

Don Evans
If you have trouble or expense getting brass tipped set screws you can do this which works just as good:
Get a brass rod that is the correct diameter to fit in the hole, cut a piece off the end that is the correct length 3/16 th inch approximately and drop that into the hole then insert the set screw.
Many years ago some machines were made this way. Probably before brass tipped set screws were made.
Don

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081