Turning

Subject:
Re: How will you remove the pulleys? Nova 3000

John Stegall
Somewhere I heard/read about using brass tipped set screws to prevent roughing up the shaft so you want have to go through the methodology John L mentioned. I think it was on Pat Warner’s site (RIP Pat). I found them at MSC, or one of the competitors. If the burr turns out to be the problem, maybe looking for those would be a solution.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081